Web site for carbie parts

[Cooper]

Many thanks for info have located a site in Canada have ordered $96.00 including postage Yamaha Pitmans wanted $125 each and Show and Go wanted $190.00 for a set of 4  I agree WD40 stuffs up rubber and composites. Coops.

[Clutch]

throw out the wd40 and get yourself some lanotec, does everything wd40 does and does it better

[beemeerr11]

OOOOPS,

Didn't know that, It's too late now as I have fitted theme, wish I knew about the silicone spray.

That's the great thing about this site, you always learn something?

Lou
 

[Christian Raith]

Same link in the post before this one

http://www.ebay.com.au/itm/YAMAHA-XS1100-SPECIAL-XJ1100-INTAKE-CARB-HOLDERS-/110749043155?pt=Motorcycles_Parts_Accessories&hash=item19c92849d3

Hi all does anyone have a contact for carbie parts Im looking at replacing the four rubber boots [from carbie to cylinder head] to start with Many thanks Cooper

Hey Coops, I just replaced the ones on mine, as they were all cracked on the outside and I thought they were the reason the bike was running really bad down low, but the rubbers were all good on the inside, I have replaced them anyway and will keep the originals aswell, I think I payed about $98 delivered from the US earlier this year when our dollar was doing really e=well,and that included a gasket for each one also, althought the originals had no gasket, there is a place in SA that had some originals and want $400:00 for them, at that price they can keep them till they perish. I find a bit of WD helps the carbys slide in easier.

Good luck

Lou

[Christian Raith]

Don't used WD40 on the rubber, it will stuff it.

Use Silicon spray

[beemeerr11]

Hi all does anyone have a contact for carbie parts Im looking at replacing the four rubber boots [from carbie to cylinder head] to start with Many thanks Cooper

Hey Coops, I just replaced the ones on mine, as they were all cracked on the outside and I thought they were the reason the bike was running really bad down low, but the rubbers were all good on the inside, I have replaced them anyway and will keep the originals aswell, I think I payed about $98 delivered from the US earlier this year when our dollar was doing really e=well,and that included a gasket for each one also, althought the originals had no gasket, there is a place in SA that had some originals and want $400:00 for them, at that price they can keep them till they perish. I find a bit of WD helps the carbys slide in easier.

Good luck

Lou

[Christian Raith]

There is a few in the Parts Suppliers board. Mostly overseas. Price should be max $120 usually about $95.

http://www.ebay.com.au/itm/NEW-YAMAHA-78-81-XS1100-82-XJ1100-J-MAXIM-CARB-HOLDERS-/190582921501?pt=Motorcycles_Parts_Accessories&hash=item2c5fa0991d

http://www.ebay.com.au/itm/YAMAHA-XS1100-SPECIAL-XJ1100-INTAKE-CARB-HOLDERS-/110749043155?pt=Motorcycles_Parts_Accessories&hash=item19c92849d3

[Cooper]

Hi all does anyone have a contact for carbie parts Im looking at replacing the four rubber boots [from carbie to cylinder head] to start with Many thanks Cooper