XS1100 AUSTRALIA
XS1100 Topics => Workshop => Topic started by: steveh on January 14, 2013, 08:31:14 PM
-
Anyone out there who can point me towards somewhere that can inspect the barrels and advise what should be done with them if anything needs to be done.
I havent an internal micrometer to measure them.
Thanks for any help that can be given
-
Steve ,a simple compression test of all cylinders will tell you where your at regarding performance and general condition..........make sure you correctly adjust the shim/valve clearance before you do this.
A way to measure wear on both the barrels and rings at the same time........is to measure the gap where the ring meets.... whilst the piston and rings are still in the bore.
A visual inspection internally of the barrels will show any scratches /damage.............
Usually a hone of the cylinders and new rings with a clean up of the pistons......decoke.......will suffice.
What is the reason you wish to check the barrels.
-
I have the head off because one of the valves is stuck so Can't do a compression test now.
I will do some measuring of the rings and hone sounds good.
I was also looking out for someone reliable if I need someone to do some work for me in the future, so any recommendation would be good to have.
Thanks
-
I believe Mal Pitman is in the Adelaide area and knows his way around an XS. and also working on a couple of members bikes at the moment
-
Thanks for the info..
-
Just had top end rebuild, new pistons and rebore done n my 81' model by Deon at Yamaha Retro in Adelaide......give them a call...Alice
-
Alice, did you go the big bore route or just factory spec pistons etc?